Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Da Vinci AIO Repetier z-axis problems

After flashing repetier, i have tryed to calibrate..  -4.8 higher is not possible becaus the nozzel hit the bed...

if i start a print the first layer will start around 5mm in the air. (gap betwen bed and nozzel 5mm) what i am doing wrong?

Some video guides on youtube says level to around -1.5mm?

can someone help?

Forum Jump:

Users browsing this thread: 1 Guest(s)