Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OCTOPI with 2 Davinci 1.0 question
#1
Question 
Im trying to set up OCtopi with 2 davinci printer 
Just notice when i flash repetier to the davinci they all have the same 

idVendor=2341, idProduct=003e
SerialNumber=0
Has anyone being able to set up their printers 2+ with OCtoprint ? 
with the printer having the same info im not able to set a rule to name the printer individually

IF someone can shine some light my way Huh Huh  PLEASE 

Thank you
Reply
#2
Anyone ?
Reply
#3
(08-01-2016, 11:42 PM)fvargasfrank Wrote: Anyone ?

Haven't done it on Octoprint/Raspbian, but lsusb in terminal should tell you more info about each USB device & allow you to differentiate.   I'm not 100% sure it will be boot-proof, but it should work.
Reply
#4
I think the problem is when you flash repetier host it remove SerialNumber from the machine and makes 0, wondering if their is a way to add a serial number when flashing it
Reply
#5
(08-11-2016, 06:52 PM)fvargasfrank Wrote: I think the problem is when you flash repetier host it remove SerialNumber from the machine and makes 0, wondering if their is a way to add a serial number when flashing it

Were you able to differentiate in terminal?  If not,  then it is probably not going to work to have two printers on one octopi setup.  It might be that a raspberry pi on each machine with its own octoprint setup would be the way to go. Sorry I can't help more,  I haven't tried multiple printers from one setup.

Kieth
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)