Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Temperature small nozzle
#1
Your Print Temperatures Guidelines are well done and clear,
But if a smaller nozzle is used (eg 0.25mm) you have any suggestions on how to change (especially for ABS) temperatures?
Reply
#2
I am having the same issue. I want full control over extruder and bed temperature. I downloaded the arduino file to jump the EEPROM chip, but apparently XYZ patched it so you cannot do this. I wrote Voltivo customer service, and the rep said that code is too old, it won't work anymore, and directed me to the forums. Have you found anything?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)