Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Replacement 1.0A Board
#1
Hello!


I recently discovered that while installing the E3D V6 Hot end I did a poor soldering job and fried the 12v supply to the rest of the board, such as my heating element which isn't allowing my extruder to heat up as well as lack of an LCD screen.

I was wondering if there is a way to get a replacement 1.0A board/ does anyone have a non-functional Da Vinci 1.0A that they can spare a board?
Reply
#2
(06-26-2016, 12:00 AM)CasMz Wrote: Hello!


I recently discovered that while installing the E3D V6 Hot end I did a poor soldering job and fried the 12v supply to the rest of the board, such as my heating element which isn't allowing my extruder to heat up as well as lack of an LCD screen.

I was wondering if there is a way to get a replacement 1.0A board/ does anyone have a non-functional Da Vinci 1.0A that they can spare a board?


Where are you located? Non atmell failure board I can usually repair for around 75 dollars plus shipping. Atmel failure is 100 flat rate plus shipping. A new davinci 1.0 is on sale for $299.00 at newegg.com

Kieth
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)