Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Da vinci AIO Repetier 0.92 No filament when printing
#1
Hey guys i got a Da vinci AIO the other day and i upgraded to the Repetier 0.92 firmware today, All seems to be working fine but when i try to print there is no filament being extruded. Filament runs out when i install new filament but nothing when printing, I am using Repetier-Host with slic3r is there something i am missing maybe in the Gcode any help would be much appriciated.

Thx
Bammoo
Reply
#2
(05-14-2016, 07:02 AM)Bammoo Wrote: Hey guys i got a Da vinci AIO the other day and i upgraded to the Repetier 0.92 firmware today, All seems to be working fine but when i try to print there is no filament being extruded. Filament runs out when i install new filament but nothing when printing, I am using Repetier-Host with slic3r is there something i am missing maybe in the Gcode any help would be much appriciated.

Thx
Bammoo

Yes typical slicer issue - you should share you gcode to get help
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)