Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
stepper motor, belt pulley for x
#1
i recently had a stepper motor go out on my davinci duo. i bought a minebea 17pm-k101-03v stepper it is 1.8 step angle 1.0A  4 ohms resistance holding torque 25oz.in.  my question is will this work as a direct replacement? as i use stock davinci duo.  also and maybe a bigger question what pulley do i now buy to replace the one i can't get off? any 20 teeth 5mm bore? or does the spacing matter also i measure about 1.25mm between the teeth.  can someone give me a direct link to one please?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)