Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Printing Iratic
#1
I seem to be having a problem with my 1.0A, was working fine untill the fillament got stuck and stopped the head moving,
 
when i try to do a print (been using the inbuilt test ones) it prints the first two lines first then when i goes to print the object it just seems to go mad and print all over the place.

I have retentioned the belt as on XYZ site but not solved the issue.

i did get a 0030 error but that seems to have gone 

any suggestions would be welcome

Sad
Reply
#2
(03-05-2016, 06:08 PM)dhd822 Wrote: I seem to be having a problem with my 1.0A, was working fine untill the fillament got stuck and stopped the head moving,
 
when i try to do a print (been using the inbuilt test ones) it prints the first two lines first then when i goes to print the object it just seems to go mad and print all over the place.

I have retentioned the belt as on XYZ site but not solved the issue.

i did get a 0030 error but that seems to have gone 

any suggestions would be welcome

Sad



Sounds like you have a broken wire. There are several threads about the 0030 error and almost all of them have come back to a broken wire.

Kieth
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)