Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Da vinci 1.1 plus not reaching temp
#1
016-02-04 22:50:28
  • Member
  • Online
  • Registered: 2015-10-12
  • Posts: 21


As title suggests.
Ive recently replaced my thermistor, due to old one been damaged, and then shortly after the prints were all bumpy.
Turned out the nozzle was mis shaped somehow, so I bought a new block and heater and thermistor, then the heat would get stuck around 140C.
Replaced everything, no joy. So ordered the e3d? full set and basically used the end/thermistor/heater from that. It was getting stuck around 170, did a printer reset and now about 190 but that's all it does hangs there and wont load/print.
Also slow getting there (Bed heats up quicker than nozzle which is not normal). Any ideas? Is it a heating problem or is there any way my da vinci thinks the temp is lower then it is so heater cant heat up enough to match da vinci's settings. Which is why it hangs?
Going to get laser temp reader tomorrow to check hot end to see if it actually is high or low. 


Since been told that I can't swap in a standard 100k as they're different. But don't have original thermistor? 
Any help appreciated.
Reply
#2
The stock thermistor is 100k so the E3D one should work fine.
Davinci 1.0 with repetier 0.92 & E3D hotend
Slicer - Simplify3d 


Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)