Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wiper/Extruder nozzle too low/high
#1
Hi all, I recent did the e3d v6 upgrade on my Da Vinci 1.0, also flashed the latest Repetier. I see the the nozzle is too high and not making contact with the wiper, anyone else have this issue or know how to solve it?
Reply
#2
The only way your going to be able to fix that issue is to remove the right side case covering and remove the drip box and drill new holes and move the box up physically. You should probably take some measurements before removing the box to know how high to drill the holes.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)