Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problems with Repetier 0.92 on a Da Vinci 2.0A Duo
#1
Hi,

i recently installed Repetier 0.92 on my Da Vinci 2.0A Duo. It seemed to work very well until I tested the left extruder (Extruder 1 in Repetier). I use Simplify 3D as slicer software. If i start a print with the left extruder it overdrives one axis (I think the x-Axes) for a short time. Does anyone of you have the same problem or even better a solution for that problem? Do you know other slicer software that doesn't cause such problems or is the error firmware related? I don't want to test more because I don't think its very good for the printer if the x-axes is constantly overdriven...
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)