Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Large Volume Prints
#1
I'm having trouble printing a rectangular sleeve that's 100x100x150 mm. The prints fail no matter what I try. I have two DaVinci Duo printers.

On one of the printers the corners of the print job warp and pry themselves off the print bed, causing the print to fail later on when the extruder slams into the side of the print job. I tried using glue, and then using ABS juice to better secure the corners, but they keep warping.

On my other printer an odd pattern of bumps appears along the back edge of the print job. The bumps get worse and worse until the job fails. I've tried adjusting the leveling to compensate, but in the end the job fails. The corners also warp and detach from the print bed.

Does anyone have any ideas?

Thanks in advance.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)