Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Extruder Heat Keep Climbing Until Decouples
#1
I bridged the fuse/resistors on the board to get the extruders working again, but extruder 1 just keeps going. It's not resisting I assume? I've switched thermistors and checked all the wiring. I can't figure it out. Anyone know what to check to find out why it won't stop climbing? Thanks.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)