Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
e3d v6 with repetier Heater cartridge issues....
#1
Maybe i have a bad thermistor, but i recently flashed my da vinci 1.0a with repetier and I also added the e3d v6 hot end. When i try o load filament or just plain heat the extruder, it reaches about 130 C and then says its "decoupled" Im guessing the thermistor is shorting out when it gets hot. Does anyone recommend a settings adjustment to fix this? or should i just change the thermister and go from there? I already tried different hearter cartridges with no luck.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)