Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Issue with Cura and Repetier Host
#1
Whenever I try to print using CuraEngine, the temperature I set for the specified filament is not the temperature that the machine heats to. For example, I try to set the print temp to 225 degrees and bed temp to 98 degrees, but when I open the manual control tab, the print temp is set to 210 and the bed temp is set to 50 and I have to manually change the temperatures from there. Any ideas on how to fix this? Thanks
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)