Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
XYZ 1.0A Repetier printer stall
#1
I recently flashed my DaVinci 1.0a with repetier 0.92 firmware, and am running repetier host 1.6.0. Im experiencing an odd fault. The printer starts the job normally and runs for some time. Then it stalls. The display on the printer shows one item in the buffer. I'm not getting any errors in the log on host. Is there any way to read the buffer from the printer and determine what command was issued? Thanks in advance for any assistance.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)