Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Questions about Repetier.
#1
I have a few questions about the Repetier firmware.

Is there any way to have it automatically preheat the bed and extruder to a set temperature when I turn the printer on?

I'm having a problem with the hot end going to the home position after it finishes the print. It goes home and does it's self cleaning the it goes to the corner of the bed and stops. I've messed with the gcode but I doesn't help.

I have my raspberry pi setup with octoprint and Repetier host on my laptop. Is there any way to send a print directly from my laptop top to me printer without using the octoprint gui?

Thanks
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)