Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Repetier questions
#1
I have installed Repetier on my printer and had a few questions about it.

Is it possible to get the printer to pre heat when I first turn it on? The OEM firmware does this.

Is there any way to get the hot end and bed to heat up at the same time when I send a print to it? It keeps heating the bed up first the heating up the hot end.

Does anyone have an config files that they will share?

Thanks
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)