Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Extruder not heating up with Repetier
I can change the temp on the printer it's self but when I try to print with slicer the the extruder won't heat up. The bed heats up fine.

Does anyone know what the problem is?
I was able to get it to heat the extruder once. When I send a print to it the display shows the current temperature and the set temperature for the extruder and bed. The extruder shows the set temperature is 0, the bed shows 90.
Hello Steve

Try going to your slicer settings and see if you have set the tempeture correct. If you are using slic3r go in slic3r settings -> filament settings end look at the tempeture settings here.

Greetings Sieuwe
I have first and other layers are both set at 220.

Forum Jump:

Users browsing this thread: 1 Guest(s)