Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
No power to LCD back light, build plate or extruder
#1
I was about 2 hours into a 2.5 hour build when I noticed that the temps were dropping on the exstruder and the build plate. I also noticed that the back light on the LCD was not working. I powered off the machine and back on again and the same issue. I can move the motors through the Repetier intervace and when I press the buttons on the LCD, I hear clicks so I'm assuming it works, just no back light. I've done a little investigating, no bare or frayed wires. Any idea where to look, perhaps a fuse or fuses on the logic board, power supply?

I have a Da Vinci 1.0A with Repetier .92.


Dale
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)