Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Temperature tables
#1
Does anybody have a custom temperature table for a Da Vinci 1.0A with an E3D V6 hot end? (Semitec 104GT-2 thermistor)
The Vinci' has an extra resistor in the circuitry which gives it a reading completely different. The closest table I can find within the Repetier software is number 5.
Thanks
Reply
#2
That is the subject of quite a bit of discussion on these forums. Personally I removed the resistor (R29 on the 1.0A main board) and used table 8. It is a perfect match.
Reply
#3
Hi, I might just do that.

Where is the R29 resistor? I cant seem to find it (But that's because I'm as blind as a bat)

Cheers!
Reply
#4
So I think I found R29, but there's nothing there...?

There's a white dot there instead?
Reply
#5
Hey Brad, Sorry for the late reply, I have been out of sorts lately.

Here is a link to another post which has a good picture of the R29 location: https://forum.voltivo.com/showthread.php?tid=8308 That is the same spot that I found mine at, I just popped it off with a soldering iron.
Reply
#6
Be aware that it is entirely possible that we have different boards, the location or even the resistor number may have changed....
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)