Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Replacing Extruder with one from XYZ
#1
So I ordered and installed a new extruder, the replacement part from XYZ. I use repetier firmware and now the stepper that feeds the filament doesn't seem to work. Any ideas?
Reply
#2
My initial guess would be a loose connection or broken wire. Take the extruder apart and then once it heats up send commands to extrude and see if the stepper is moving. If it's moving then the wires are okay and the problem is the alignment or the feed not engaging correctly. If it's not moving then you need to look for wires. Best of luck.

Kieth
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)