Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Right extruder prints at incorrect coordinates
#1
Hello and thanks in advance. I am pretty new to this but learning. My issue is that I can't get the right (T1) extruder to print at the correct Y location on the plate. I am using Repetier version 0.92mod and slicr3. I've that the firmware will adjust the offset so I haven't tried to adjust in the hosts setting. Thank you again for any assistance.
Reply
#2
Yes second extruder position must be calibrate compare to first one as every printer are different - X and Y offset need to be modified in EEPROM not in host / slicer - adding offset in host/slicer will result a mess
Search in forum - I have already suggested some stl to help to do calibration
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)