Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
G-Code command
#1
Hey there,
Just curious what the G-code command is to get the heating bed to drop to the bottom off my AIO, because when my AIO finishes now, it stays in the exact location of the last print command, the extruder and bed start cooling immediately but the bed does not lower so I can remove my printed item.
Any help would be appreciated. thanks
Reply
#2
ld like to know this too and when you are in notepad++ what do you change the first three lines too before saveing it as a .3w or do you have too my printer comer in a few days and trying to get ready for it. any links or help would be cool.
Reply
#3
Note sure which of the following causes the bed to lower but this is what is at the end of mine.

Code:
; layer end
M103 ; turn off extruder and retraction
M104 S0 ; turn off extruder
M140 S0 ; turn off bed
M107 ; turn off fan
M127 ; turn off valve
M84 ; disable motors
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)