Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Post flash issue
#1
I finally grow some and flash my 1.0A. The flashing part went fine but now when I powerup the printer, the extruder temp show -11c and within 2 seconds DEF show up. I have a E3D V6 installed and was working fine prior to the flash. Any help would be greatly appreciate. Thanks in advance.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)