Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cutting a stl in half?
I have a few stl files that were created by someone else and I was wonder if there is any simple way to cut them in have then load them backup in the default Da Vinci software? I have Sketchup and Slicer but I don't know much about Slicer and I know enough about Shetchup to make my own simple designs.

netfabb basic is what i use to split stl files in half.
It is real easy to split the file with Netfabb basic but I am having trouble figuring out how to save it.

I found it. Thanks

Forum Jump:

Users browsing this thread: 1 Guest(s)