Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Print slows down near the end of the print
#1
I have a problem where i print a file (i have tried multiple files) it starts out fine but the last few lines of the print prints extemely slow, it takes longer than 30min to print a part that should take 3 minutes
Reply
#2
Printer?
Slicer?
Firmware?
What modifications?

A lot more info is needed to even guess.

Kieth
Reply
#3
Sorry here is more info

Printer - Da Vinci 1.0
Slicer - Repetier Slic3r
Firmware - Repetier 0.92

no other modifications were made, i use abs for printing and glue to hold it to the plate
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)