Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Print won't start in the middle
#1
First off, complete noob here so bear with me.

I am printing on a DaVinci 1.0a using Repetier .92 firmware (learned how to flash from this forum!) and Cura 15.04. I've been printing fine since flashing the machine until today. Suddenly, the printer will not begin a print in the middle of the print bed like it always has. It begins at the back right corner and then prints off the print bed, causing the nozzle to run into the back and side of the bed. I didn't change any settings in Cura nor on the printer itself.

The only other thing that I have noticed that is different about the printer is that after a few minutes of the machine being on, the LCD screen gives me a "stepper disabled" message. I have opened the back of the machine trying to cool it off, but I still get this message. The message and the problem of not printing in the correct position started at the same time.

Any help would be greatly appreciated.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)