Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Priming second extruder ?
#1
Hello,

What GCode commands should I give to prime the second extruder along with the primary ?

G92 E0
G1 E-2.0000 F1800
G1 Z0.600 F2400
; layer 1
Z = 0.6
T0
; tool H0.600 W0.480
; outer perimeter
G1 X11.727 Y110.865 F3600
G1 E0.1000 F540
G92 E0
G1 X14.053 Y110.865 E0.2288 F630
G1 X14.053 Y187.194 E7.7334
G1 X13.924 Y187.194 E7.7461
G1 X13.924 Y110.994 E15.2380
G1 X11.856 Y110.994 E15.4413
G1 X11.856 Y187.194 E22.9331
G1 X11.727 Y187.194 E22.9459
G1 X11.727 Y110.865 E30.4505
G92 E0

Thanks
Reply
#2
1) If you made the gcode with slic3r like I do, you need to first go and add the second extruder to slic3r and make sure you have selected that before you export the gcode
2) If you scroll all the way down there should be several options to edit things. one of them will probably say "extruder" or something. It is usually set to 1. Just change it to two. Also make sure you change values like what extruder you use for supports, etc. Just go through the list, there should be plenty of stuff there to go over. It works for me with my 2.0 on official firmware.
Also a note for any one who is a rookie at importing files from slic3r to xyzware for control without modding, remember that you need the change the value of machine from daVinciF10 to daVinciF20

If your gcode doesn't look anything like mine, sorry to have wasted your time Tongue
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)