Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Repetier Server
Hi all, I've just been getting my Da Vinci 1.0 set up with Repetier Server through a raspberry pi. I was wondering if anyone else has done this and if they have any tips on what the proper printer settings are? I did an "autodetect from firmware" to fill the settings, but a lot of them seem wrong. any and all help will be greatly appreciated
Don't know if it helps, but I've been running octoprint on a raspberry pi for many months. For me, it is the best solution.


Forum Jump:

Users browsing this thread: 1 Guest(s)