Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Printerbed moves in wrong directions after flashing firmware
#1
Yesterday I (re)flashed my da vinci with the repetier-firmware and made a fresh install of repetier host. All went fine, except on manual control in RH, the bed travels in opposite directions and makes a high-pitching sound (during travel).

Does anyone have a clue? Did I by accident change some firmware value?
Reply
#2
Sounds like you have some firmware settings wrong. Did you load and save the details as per the FAQ on github?

Kieth
Reply
#3
From the Config menu open the Printer Settings dialog box, on the Printer tab there are three check boxes that will "Invert Direction in Controls." That may help...
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)