Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Communication woes
#1
So i upgraded my 1.0a to repetier yesterday finally and all was going very well. Unfortunately now i cannot communicate with the printer. I can manipulate the printer with the lcd screen, and i can "connect" in rep host, but its not actually connected, no communication. My baud rates match, and it was working. Now no go, i have reset the printer, the computer, moved the plug to dif ports, sometimes it will eventually start working again after dicking around like this for a while. But next time i start my computer up its the same old story.
I have tried all sorts of "fixes" i have googled and nothing has worked. Any suggestions? Should i just reflash it? and if so whats the safe way to do that?
Reply
#2
I'm very suspicious your problem lies with some setting within repetir, specifically the selection of firmware or printer type.

Kieth
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)