Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Calibration and Print Issue
#1
I'm new to 3D Printing and I purchased my Davinci 1.0 about a month ago. The glass bed broke and XYZ sent me a whole new bed to replace. So I did, now I cant print =( I am able to get it to complete the stock calibration...but then the extruder is like 5mm above the glass when it prints so it just drops plastic out. So I did the piece of paper on the glass manual adjustment, It starts to lay plastic after that...Not perfectly but its a start...However at that point the bed is so high when the head cleans itself it actually hits/rubs the bed and of course the built in calibration thinks its WAY off when I do the manual adjustment. Any help is appreciated.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)