07-13-2015, 06:56 PM
Hey,
I have been using the Voltivo PLA with my Da Vinci 1.0A for quite some time now with great success (my only hardware mod is this: http://www.thingiverse.com/thing:623274, and I'm running repetier 0.92). After experimenting with additional heatsinks without success, I started to get prints that did not stick very well to the heated glass bed, and were also not plain but rounded at the bottom (see picture).
I also have two small indents in my glass bed, I think they splintered off during a print.
My question is: Could anyone tell my what might cause this rounded bottom/non-sticking? It makes printing near impossible.
Best Regards
Jakob
I have been using the Voltivo PLA with my Da Vinci 1.0A for quite some time now with great success (my only hardware mod is this: http://www.thingiverse.com/thing:623274, and I'm running repetier 0.92). After experimenting with additional heatsinks without success, I started to get prints that did not stick very well to the heated glass bed, and were also not plain but rounded at the bottom (see picture).
I also have two small indents in my glass bed, I think they splintered off during a print.
My question is: Could anyone tell my what might cause this rounded bottom/non-sticking? It makes printing near impossible.
Best Regards
Jakob