Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cannot print anything, carrier "jumps"?
#1
Over the past few days my 1.0 (repetier firmware) has developed this issue where it cannot print anything due to sort of shaking so to speak. Not sure how to explain it, I took a video:
[video]http://vid1194.photobucket.com/albums/aa376/pbcrazy96/Mobile%20Uploads/trim.0A068245-9ECB-4399-8975-E5CAFAFA7233_zpszyidppqi.mp4[/video]
Link if video window doesn't show

I also have the typical x-axis offset problem, which I will fix soon, not sure how this could be related but it might :unsure:

Any ideas?
Reply
#2
Check your pulley and gears. Sounds like something's broken. More than likely it could be the idler wheel on x axis
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)