Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help a newbie out. Using 3rd party filament on da vinci
#1
Hello everybody. I am very new to 3d printing and da vinci 1.0. I just recently purchased a filament resetter but after reading the instruction i realized i might screw things up. I am looking for some help on figuring out if my printer firmware and xyzware is the best one to use with the reseter and 3rd party filament. I am using a mac version of xyzware 1.3.10 and firmware 1.0.1. Do i need to downgrade my firmware and block xyzware from internet or am i good?

Thank you,

T
Reply
#2
So anybody willing to help here?
Reply
#3
Your firmware is OK, no need to downgrade. You do need to block xyzware from "phoning home" however.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)