Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Maximum temperature
#1
Hello

What is maximum temperature that these machines are allowed to print at? In firmware is limitation of 270 and there are filaments that are set to 260 for extrusion. Is it safe to use it ? I have one fan Da Vinci version.
Reply
#2
I have run 260 without a problem with a custom filament and is working.
Reply
#3
Just curious. Is the 260 temp read from Repetier or from a thermometer on the hot-end? Also, at that temp did you not have filament swelling due to heat creep?

Thx.
Reply
#4
sorry for the late reply. I was in vacation overseas.
both temperatures were measured. They vary in 2 *C. Tip end was 2 degrees lower than the machine reported temperature. Measured with a K type thermocouple on a fluke thermometer.
Filament started to swell at around 210...

regards,
DH
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)