Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
bed question
#1
I am pretty sure I have the bed leveled and homed ok, However, if I tell the printer to print samplecode from sd card, it dropd the bed to z of 35 and prints in mid air.

any nudges on how I can correct this?
Reply
#2
Sample codes from sd card should not be used. If your using rep.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)