Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Repetier set bed z height
#1
Hi everyone, just installed repetier on my Da Vinci 1.0a, it went all fine until I try to print. The extruder head keeps on hitting the side of my bed. Not sure if I'm doing it right but I tried to autolevel the bed, set the z axis of the bed and on settings set the bed z axis as well. But bed will move up when I started to print again. Thanks in advance
Reply
#2
https://forum.voltivo.com/showthread.php?tid=8706
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)