Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Repetier controls
Hi, I am having some problems with one of my extruders and I am waiting on a new transistor to come in the mail to make the repair. I was wondering if there is a way to disable the bad extruder in the firmware so I can use the second exruder on its own. Currently I am not able to use my printer because extruder one is reading -20 for a few seconds and then it goes to def.
Any help would be greatly appreciated.
which extruder is not working right or left?

Forum Jump:

Users browsing this thread: 1 Guest(s)