Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MK3 heatbed with 100k resistor, repetier config
#1
I am just about to try fitting a MK3 RepRap heatbed to my Da Vinci since my original glass has broken. I'm fairly confident I can get the heatbed to fit and I could use the original thermistor I think. But if I use the 100k thermistor that comes with the heatbed, is it just a case of changing the heat bed thermistor type in configuration.h to the 100k type?

Thanks, Matt.
Reply
#2
not sure, but I noticed on my board that the bed thermistor circuit seems to be a standard setup. A single Resistor (as opposed to the dual resistor for the exstruder) so I suspect it may work fine with the existing table.

Let us know how it works out.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)