Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Automatic bel levelling
#1
Hello,
Is it possible to use automatic bed levelling in repetier on the DV 1.0?
I mean, put some sort of measurement on the Z, and adjust the printbed height automaticaly?
Thanks!!
Rudy
Reply
#2
Sorry what is the difference with the current auto leveling feature ?
Reply
#3
You speak of the menu function in the Repetier v0.92?
This works the same as the Original XYZ firmware, with the 3 measuring points?
And is it a dynamic, so does the Z move duren printing a layer if the bed is not level?
Thanks,

Rudy
Reply
#4
yes this is called auto levelling - what are you looking for exactly ?
Reply
#5
What i would like is a kind of probing, let us say at 5 positions, and that the 5 positions are used to calculate the Z height during the printing.
The motherboard of the davinci has the probing input, and i could use some kind of probe, maybe removable to make contact during probing (a ramps can do this with a servo, but the DV motherboard does not have a servo output)
Thanks for your time ;-)
Reply
#6
WORKS!! just had to activate it.
Some tweaks to get other positions, but good for a starter.
Getting it reliable will probably be more difficult ;-)
Reply
#7
Quote:WORKS!! just had to activate it.

How did you activate it?
Reply
#8
Menu>>Maintenance>>Auto Level bed, then everything goes automaticaly ;-)
Reply
#9
even it is not complete with all functions available - here is the advanced menu, the easy one is also on github
[img]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)