Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
calibration of bed
#1
I've been reading the posts but I can't seem to get past the err,err,err. I leveled my bed with a micrometer so I know it's level but what is my next step.
Reply
#2
it took about 3 hours but I got it figured out. The bed was so far from the nozzle that the tip couldn't make contact. I measured the length of the screws on the other bed and adjusted it and got it into the fail mode so then i just kept adjusting until i got success.
Reply
#3
You might still want to do a manual calibration using the paper method.
I usually find that the first layer still isn't right after an auto cal.
I no longer bother with the auto cal and just set the bed height manually. It really isn't worth the hassle fighting with it.
Davinci 1.0 with repetier 0.92 & E3D hotend
Slicer - Simplify3d 


Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)