Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Mk9 extruder calibration
#1
I'm trying to calibrate my extruder. Steps are calibrated yet I seem to be getting flow rate issues. First off the filament is not sticking great and higher temps make it worst. The filament also seems thin when extruded even when speed is drastically lowered. Do I need to adjust the flow rate? No jams, filament flows perfectly
Reply
#2
Fixed my problems with filament flowing, now I am having problems with the prints ticking to the bed. Kapton tape and acetone wont even touch it. I am running it at 90C, should I try 100-110C?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)