Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Change 0.4mm nozzle to 0.2mm diameter
#1
Change 0.4mm nozzle to 0.2mm diameter
FW:1.1.G
SW:Simplify3D & XYZopenmod
filament: PLA
layer: 0.2mm
perimeter shells: 2
speed:30mm/s[Image: LINEcamera_share_2015-04-08-22-11-15.jpg][Image: LINEcamera_share_2015-04-08-22-02-32.jpg][Image: LINEcamera_share_2015-04-08-21-00-00.jpg][Image: LINEcamera_share_2015-04-08-21-26-35.jpg]
Reply
#2
If you changed extruder to E3D V6 hotends
you should try tihs
0.2mm nozzle is a very good thing~~~~
It makes your Da vinci "POWER UP"[Image: IMAG2848.jpg]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)