Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
repetier e3d configuration help
#1
I just got my e3d v6 setup installed and working(somewhat) on my 1.0 but I'm getting terrible print quality. I was wondering if anybody that is running a 1.0 with e3d v6 setup(I am also running a bowden extruder) could post their configuration files. Also, on a side note: at ambient room temp my extruder temp is perfect, but in order for me to print at all I must run at 250-265C as opposed to the 230C I ran on the original setup. I have bypassed the breakout board. Does anybody know why this would be happening?

I would appreciate it!

EDIT: After attempting to print a piece at 265C my print quality is much better but still much worse than the original setup.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)