Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Clear ABS filament on Repetier 0.92
#1
For some reason, I can't print clear ABS anymore after upgrading to 0.92. On 0.91, I was able to print clear filament. Now I get a message on the daVinci about filament not loaded. Works fine with other colors.

Is there a way to disable the extruder from checking? I'm assuming it must have some sort of light sensor, since clear doesn't block light, it thinks there is no filament inside?
Reply
#2
yes disable filament sensor in settings
Reply
#3
Thanks! I thought I had to junk my clear ABS Smile I appreciate your work on repetier.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)