Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What Upgrades / Firmware.
#1
First off I want to say hello to everyone...this is my first post. I have been reading your posts and just joined yesterday. I have a Makerbot Z18 and they finally got it right...I've had it 4 weeks and have over 200 hours of printing, with 60-70 hour prints. Well 2 days ago I was looking online and long story short I decided to purchase the Davinci 2.0. I'd like to get your opinions on this unit and what you would do if you were me to make it a better unit. I'd like to use filament other than their cassettes, is that possible? Also I've read about some programs (simplify3d, repetier..not sure if it is correctly spelled) any help would be appreciated. Thanks so much.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)