Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Simplify3D G-Code Scripts
#21
If you use another slicer wouldn't specifying temp in GCode be needed?
Reply
#22
(05-18-2016, 06:01 PM)viperz28 Wrote: If you use another slicer wouldn't specifying temp in GCode be needed?

It depend of your slicer - normally in start gcode you have some macro ( cura / slic3r have) for getting the temperature specified in UI like here : https://forum.voltivo.com/showthread.php...56#pid2056
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)