Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Stock FW 1.0.3 with e3d v6 is it possibles?
#1
Hi all
I was thinking to upgrade my hot end with the e3d v6. And because I have da Vinci 1.0A And I'm using S3D as my slicer. I'm thinking to skip one thing is not flash my printer. I know some of you will not agree with that. So any advice if it's posible or not. Thanks inadvance
Reply
#2
Yes it's possible. I've done it. Will release the design soon after I get everything documented and finalized.

http://youtu.be/dpZDC1HZqIw
http://youtu.be/dgInrivLf8k
Reply
#3
Wow. That's a good news. e3d v6 is on the way lol.
Thanks.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)