Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Replacing Hot Ends on a Duo
#1
Has anyone successfully swapped out the hotends on their Duo? I'm weighing whether to attempt this or instead to build a completely separate 3D printer to run some of the more exotic filaments I'd like to work with (NinjaFlex, CopperFill, etc). I've done some poking around and it seems like the majority of resources available are geared towards single-extruder DaVincis. I'm curious whether it's possible to replace a single extruder or whether both need to be swapped, how successful a single or double extruderectomy would be, and any suggestions/warnings/successes folks would be willing to share.
Reply
#2
Im interested in this as well, what route did you decide to go with?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)